Genie fault code

Genie code H067

The motor controller enable circuit is shorted to battery negative. Everything is locked out except platform down. [src]

Stop: machine locked out

Source: Genie Service and Repair Manual, GS-30/32/46/47, Part No. 1272217GT Rev E1 (October 2023), page 170. Applies to Genie GS slab scissor lifts with SmartLink: GS-1530/1532, GS-1930/1932, GS-2032/2632/3232, GS-2046/2646/3246, GS-4047.

Likely causes

The manual lists 4 causes:

  1. Short in the motor controller enable wire.
  2. Motor controller.
  3. Contactor coil shorted to battery negative.
  4. Ground control (GCON) ECM.

How to fix it

Work through these in order, as the manual's troubleshooting chart does:

  1. Check the device on the faulted circuit (coil, horn, alarm, etc.) for a short or open circuit; replace it if it tests bad.
  2. If the device is good, check the harness and connector between the ground controls and the device; repair or replace them if bad.
  3. If the harness is also good, check the ground control (GCON) ECM and replace it if it tests bad.

Call a technician: Right away. Genie says to tag a damaged or malfunctioning machine and take it out of service, and to repair it before use.

Did this fix it?

Advertisement

Sources

  1. Genie Service and Repair Manual, GS-30/32/46/47, Part No. 1272217GT Rev E1 (October 2023) (retrieved November 3, 2026)